|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
December 27th 06, 06:26 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Hmmm a BD5J with zero hours FS
It's good that you found a problem that may get your engine running
again but aren't you missing something? If your engine truly is "new", then all that injector clogging happened in just a brief ten hours. There must be an underlying systems problem that caused the clogging. Have you found that problem? If not it will just re-occur in the next ten hoursof running time. This is a valid point, don't you think? Is there something in the tanks, or somewhere in the fuel system causing the injectors to be clogged so quickly? Was there some problem previously existing in the engine? Fixing a problem is good. Fixing the cause of a problem is even better. g -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 02:26 PM |
| Commerical rating question about hours req. | Nik | Piloting | 5 | September 12th 06 05:43 AM |
| Most reliable homebuilt helicopter? | tom pettit | Home Built | 35 | September 29th 05 02:24 PM |
| First 2 1/2 hours PPL(H) today! | Simon Robbins | Rotorcraft | 42 | September 25th 05 12:54 AM |
| millionaire on the Internet... in weeks! | Malcolm Austin | Soaring | 0 | November 5th 04 11:14 PM |
Threaded Mode