|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
January 18th 07, 11:43 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Wing walk ply question.
Mine also calls for 1/4" but only from the front spar to the back spar, since I have flaps. Laminating 2 peices should be ok but I wouldn't us an 1/8" trowel. I would spred the glue around with a popsicle stick or scrap wood, quite a few clamps, and straps of wood to put on top. Clamp one end, then start clamping every couple of inches until you reach the other end. Lou 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Good news for private pilots' spouses | Skylune | Piloting | 30 | July 7th 06 11:19 PM |
| Wing dihedral | Dallas | Piloting | 35 | March 20th 06 04:01 PM |
| The Impossibility of Flying Heavy Aircraft Without Training | Immanuel Goldstein | Piloting | 365 | March 16th 06 01:15 AM |
| The Impossibility of Flying Heavy Aircraft Without Training | Immanuel Goldstein | Home Built | 331 | March 10th 06 01:07 AM |
| An Affordable Homebrue 60 in DS machine | Grant | Soaring | 0 | August 8th 03 03:52 AM |
Threaded Mode