|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#15
January 21st 07, 08:10 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Need Info On Reamers
"GeorgeB" wrote in message
... On 20 Jan 2007 18:40:24 -0800, "DonMorrisey" wrote: ... little oversize. Remember that the expansion of materials is different, binding would not be a good thing. Would you then suggest that it would be a good idea to test the fit of the sample parts after the plastic and aluminum have spent the night in the deep-freeze and again after a couple hours in a 150 F. oven (about how hot it can get with the sun beating on a closed structure?)? -- Geoff The Sea Hawk at Wow Way d0t Com remove spaces and make the obvious substitutions to reply by mail When immigration is outlawed, only outlaws will immigrate. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire Strike Info | Ol Shy & Bashful | Piloting | 13 | August 18th 06 03:33 AM |
| Helicopter Physics info online anywhere?? | [email protected] | Rotorcraft | 4 | April 24th 04 04:18 PM |
| Mooney info | eddie | Owning | 13 | March 12th 04 06:42 PM |
| POSA Carb Info and HAPI Engine Info | Bill | Home Built | 0 | March 8th 04 08:23 PM |
| Starting new info site need info from the pros | MRQB | Piloting | 7 | January 5th 04 03:20 AM |
Threaded Mode