![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#13
|
|||
|
|||
![]()
How did you route the power and antenna wires? Did you wire the power
to a circuit breaker or leave the cigar lighter plug on? Are you sure the wiring won't catch in the sprockets and chains of the aileron controls? Everything was professionally installed by McCandless Aviation in Waterloo, IA (KALO). I've looked under the panel myself, and everything is very professionally zip-tied up and out of the way. It's a fantastic improvement over the octopus of wires that comes with a yoke mount. -- Jay Honeck Iowa City, IA Pathfinder N56993 www.AlexisParkInn.com "Your Aviation Destination" |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Softcomm panel mount intercom? Junk? | [email protected] | Owning | 10 | November 26th 05 06:46 AM |
Panel mount for handheld Garmin GPSMap X96 series | Brock Boss | Owning | 2 | September 25th 05 01:26 AM |
manual for garmin 100 panel mount. | Ray Toews | Home Built | 1 | September 11th 05 10:28 PM |
Need panel mount for Delcom Radio | Mark Lenox | Soaring | 3 | June 24th 05 03:31 AM |
Upgrade handheld GPS, or save for panel mount? | [email protected] | Owning | 7 | March 8th 04 03:33 PM |