|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
February 24th 07, 12:28 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Welding 4130...
On Feb 23, 5:20 pm, "Blueskies" wrote:
and I need about 1' of 3" wide 0.065" 4130, so I am planning to buy some strips from them also. Side note, any hints on cutting the strip? Buy a metal-cutting abrasive disc (chop-saw disc) at the hardware store in a size that'll fit your table saw. It'll zip through 4130 nicely. Lots of noise, lots of sparks, so wear hearing and eye protection and make sure your work area is free of anything that might burn or smolder. Dan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GAS or MIG welding on 4130 tube? | wright1902glider | Home Built | 10 | February 19th 06 04:28 AM |
| 4130 sheet | log | Home Built | 4 | September 1st 04 01:42 AM |
| 4130 - bad news... | Richard Lamb | Home Built | 28 | May 17th 04 04:08 PM |
| IS the US out of 4130 Steel? | mallakka | Owning | 0 | April 21st 04 10:48 AM |
| Welding techniques for 4130? | Building The Perfect Beast | Home Built | 29 | September 4th 03 08:52 PM |
Threaded Mode