|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#31
March 25th 07, 01:14 PM
posted to rec.aviation.owning
|
|||
|
|||
Annual Off to a Good Start
Probably because no "airplane parts store" (including the highly respected discounter o'them all, Chief) carries anything but Phillips. .stuff snipped I'm gonna replace stainless with stainless. They are a BIT harder and don't rust up quite as bad. Stainless to speednut has never been a problem insofar as I know. .other stuff snipped Now that we have broached the subject, where do you find stainless threaded speed nuts. There are a pile of them used on Cherokees to hold on the wing/stabilator tips (8-32 I believe). I have never been able to get a source. Anyone? Thanks, Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| chicago area residential airpark and maintenance facility good deals on annual inspections | [email protected] | Owning | 7 | September 15th 05 02:55 AM |
| Good morning or good evening depending upon your location. I want to ask you the most important question of your life. Your joy or sorrow for all eternity depends upon your answer. The question is: Are you saved? It is not a question of how good | Excelsior | Home Built | 0 | April 22nd 05 01:11 AM |
| Is a 152 a good start? | AliR | Piloting | 17 | April 20th 05 05:52 PM |
| [US: PA/NY/NJ] Governor's Cup off to a good start | Papa3 | Soaring | 0 | April 13th 05 10:36 PM |
| 'Good' Annual This Year | Ben Smith | Owning | 38 | July 26th 03 05:44 AM |
Threaded Mode