President of our local EAA chapter killed in inaugural flight

In article ,
"Morgans" wrote:

"Peter R." wrote

Yesterday (Saturday) the president of our local EAA chapter here in
Central
NY (USA) and a passenger were killed during the first takeoff of their
just-completed Lancair Legacy aircraft. Sadly they had invited family and
friends to witness this first flight.

According to the news article, the pilot/president was a former B-52 pilot
during the Vietnam war and had spent the last two years building the
Lancair
Legacy.

From initial witness accounts speculation suggests engine failure on
takeoff
followed by a turning stall.

http://tinyurl.com/2p9csw

Condolences, and prayers for the family.

Not to be unfeeling, but it sounds like someone who should know better
violated two rules, generally accepted by the homebuilt community.

First, why was there family at the airport? It is said that this makes a
person have extra pressure to take off, ready or not, and is hard on the
family if things go badly.

Two, why the HELL where there two people on board? Regulations do not allow
a passenger on the first 25 or 50 hours, depending on the assigned test
period. One more person and his family experienced tragedy, needlessly.

Do you know if he did a full power test, (for what is it, that is
recommended - 2 or 5 minutes?) with the nose up as high as takeoff and climb
attitude would be?

It seems as though this is an often skipped test, that is probably the most
important pre-flight test that exists. I hope that is not the case.

I echo the condolences to all involved.

That said, I was in a chapter in CA that had three fatalities two on the
respective first flights. In both of those the builders/pilots were
secretive about their planes and did not invite other chapter members to
view the planes before the first flight. Both planes had fatal flaws.

The third had an engine problem and attempted flight anyway.

Another man here did an auto conversion in a Mustang II (both very
crude) and had an engine failure, despite other's warnings not to fly.
He apparently had a V-belt fail, which flailed about the engine
compartment and took out the ignition wiring. The forced landing in a
golf course was fatal.

Better results occurred with a friend who built an RV-4. He was doing
taxi tests and reported control/response anomalies to a friend and
myself. We recognized the anomalies and asked to see the plane before it
flew. Between us, we spotted 60 discrepancies -- some minor -- some
major and safety threatening, such as a fuel line too near an exhaust
pipe and throttle/mixture controls mounted on am aluminum plate subject
to vibration/fatigue failure. He corrected all and went on to many happy
hours in the plane.

PLEASE, GUYS! Before you fly (or even taxi test) get as many sets of
eyeballs as you can to inspect, critique, improve your handiwork!

It is not a reflection on you if something is wrong!

It is a reflection on your friends that they care enough to try to keep
you around to enjoy your company!