|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
June 26th 07, 05:51 PM
posted to rec.aviation.homebuilt,rec.aviation.owning
|
|||
|
|||
Air Compressor Horsepower/Wattage/Amperage
On Jun 24, 5:20 am, Ron Rosenfeld wrote:
... Ron, what peak starting current should I expect on a single-phase, 240V, 3/4h.p., running current=7.8A motor used to lift my hangar door? I want to rig up a genny to lift the door during a power failure. The gear train on the door is rigged so that all of the cables are slack (i.e. only motor inertial) when the motor starts. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| more horsepower | T-Bone | Piloting | 11 | March 20th 06 10:56 PM |
| Lycoming Horsepower Calculation? | Mark Doble | Home Built | 1 | June 20th 05 10:46 PM |
| Thermals and Horsepower | Ken Kochanski (KK) | Soaring | 14 | January 9th 05 05:50 PM |
| Air Compressor for RV Builder | John Bundy | Home Built | 5 | March 27th 04 01:47 PM |
| Horsepower | Andre | Home Built | 3 | July 18th 03 10:50 AM |
Threaded Mode