![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]() "Harry K" wrote in message s.com... The heat problem is not in getting rid of it. The problem is that that heat was produced while compressing the air and is then thrown away. Right there should be a clue as one of the major reasons why and "air engine" is not an economicaly viable design. That heat costs money and represents energy that cannot be recovered. This was already explained to the OP, and seems to have made no impression. Vaughn |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fuel quality control standards for aircraft rental/fuel sales... | [email protected] | Owning | 19 | January 19th 05 04:12 AM |
Airplane Parts on Ebay Vac Reg Valves, Fuel Floats, O-200 Spider, Fuel Injection Valve | Bill Berle | Aviation Marketplace | 0 | January 26th 04 07:48 AM |
Pre-Rotator Powered by Compressed Air? | nuke | Home Built | 8 | July 30th 03 12:36 PM |
Pre-Rotator Powered by Compressed Air? | Gil G. | Rotorcraft | 9 | July 30th 03 12:36 PM |
Pre-Rotator Powered by Compressed Air? | nuke | Rotorcraft | 0 | July 28th 03 12:52 AM |