|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
September 20th 03, 10:51 PM
|
|||
|
|||
Chad Irby wrote:
Mike Marron wrote: But once again, doubtful the "brainy" types in St. Louis designed the ECM pod fasteners to take shear loads in the threaded area anyway (it is a bad practice to do this with any bolt, AN or otherwise). You can "doubt" all you want, but that's not how the damned things were put together. But according to you, that's how the damned things came apart. Yea or nay? -Mike Marron 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Making your own canopy | c hinds | Home Built | 6 | November 22nd 04 09:10 AM |
| Why is a standard hold right turns? | Roy Smith | Instrument Flight Rules | 51 | August 28th 04 06:09 PM |
| need advice with composite for making glare shield | bubba | Home Built | 1 | July 7th 04 05:44 AM |
| Making my landing gear | Lou Parker | Home Built | 8 | March 31st 04 10:34 PM |
| Air Force launches rocket with secret military payload from Cape Canaveral | Otis Willie | Military Aviation | 0 | September 9th 03 09:07 PM |
Threaded Mode