|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
August 15th 07, 12:37 PM
posted to rec.aviation.piloting,rec.aviation.owning
|
|||
|
|||
Mounting 396
"Paul kgyy" wrote: How did you do the wiring to provide free movement of the yoke? Under the yoke shaft I attached an adhesive tie-wrap clip to the panel. Before I tie-wrapped the cables to the clip, I pulled the yoke out to its full aft travel. The cables then trailed below the yoke shaft along with the PTT cable. This setup was unobtrusive and caused no interference problems with the yoke. -- Dan T-182T at BFM 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mounting 396 | Paul kgyy | Piloting | 40 | August 24th 07 08:47 AM |
| Mounting Cambridge 10 in ASW-19 | jcarlyle | Soaring | 0 | February 27th 06 01:48 PM |
| ELT Mounting for an ASW20-C | Papa3 | Soaring | 11 | January 26th 06 06:37 AM |
| Mounting my GPS | Charles Talleyrand | Owning | 8 | November 19th 03 11:51 AM |
| Mounting my GPS | Charles Talleyrand | Piloting | 8 | November 19th 03 11:51 AM |
Threaded Mode