![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#8
|
|||
|
|||
![]()
If I had one I would! They were and are fun. Some
people collect them and drive them for a lark -- the kind of experience you can't get from a new, high-end car which would doubtless be more comfortable and more efficient. At 03:01 28 August 2007, Lew Hartswick wrote: At 21:43 27 August 2007, Lew Hartswick wrote: wrote: On Aug 27, 5:36 am, Steve Leonard wrote: Nah, you guys have all got it wrong! Fly a 1-26! You will land out far more often, get lots more practice at no wing runner takeoffs, and you have those big a$$ tip wheels built in! :-) Steve Leonard (Never flown a 1-26, but I learned in a TG-3A) I often wondered about those tip wheels!! I mean where basic understandings of drag and wing tip airflow even a consideration in the 1-26. Regards Al Of course not.There were this pair of barn doors and an orange crate around and ......... :-) ...lew... Nyal Williams wrote: Aw, c'mon, guys! You're acting like your ancestors didn't climb down out of the trees; well, maybe your's are still up there. What's wrong with heritage gliders? I'm sure you drive a Model T car also. :-) ...lew... |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
No wing runner? | JJ Sinclair | Soaring | 9 | August 27th 07 11:50 AM |
Soft field landings - low wing vs high wing aircraft | Justin Gombos | Piloting | 19 | May 23rd 07 05:21 AM |
Books on Military Rotary Wing to Civilian Fixed Wing Transition? | Greg Copeland | Piloting | 5 | May 2nd 07 03:23 AM |
Anyone building/flying a Ridge Runner? | Russell Duffy | Home Built | 10 | September 16th 05 02:58 PM |
Mylar tape wing seals - effect on wing performance | Simon Waddell | Soaring | 8 | January 1st 04 03:46 PM |