|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
August 28th 07, 10:53 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Enlarging a bushing hole?
wrote in message oups.com... On Aug 27, 7:59 pm, John Ammeter wrote: If you have a lathe or access to one it's simple. Just chuck the bushing in the lathe with the drill bit mounted on the right side... can't think of the name of that part.. --------------------------------------------------------------------- That'd be the Wifferdoodle. (Although some folks call it the Tail Stock.) -Bob Hmmmm, and I thought it was a tale stock ;-) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Worm Hole no Need for Black Hole | Michael Baldwin, Bruce | Products | 2 | May 8th 07 11:04 AM |
| Jackson Hole TFR | [email protected] | Piloting | 24 | August 23rd 06 04:35 PM |
| Even during sentencing, this guy is an a*hole | H.P. | Piloting | 45 | March 14th 06 11:36 PM |
| Hole Finder | [email protected] | Home Built | 2 | March 6th 06 02:32 PM |
| Rubber Bushing Replacement | Boelkowj | Home Built | 8 | December 12th 03 12:45 AM |
Threaded Mode