|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#17
September 16th 07, 02:27 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Enlarging a bushing hole?
On Mon, 27 Aug 2007 20:42:47 -0400, Michael Horowitz
wrote: I find myself having to enlarge a bushing's ID by 1/16ths to 3/8ths. My concern is I don't know how to insure the 3/8" bit is aligned with the axis of the hole. Centered is good, but I'm more concerned with the alignment. Suggestions? - Mike I went to the machine shop around the corner with the intent of picking their brains. He took one look at it and said "push out the old bushing and push this one in". The new bushing had the ID I was looking for. Total time - :15 - Thanks for the replies - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Worm Hole no Need for Black Hole | Michael Baldwin, Bruce | Products | 2 | May 8th 07 11:04 AM |
| Jackson Hole TFR | [email protected] | Piloting | 24 | August 23rd 06 04:35 PM |
| Even during sentencing, this guy is an a*hole | H.P. | Piloting | 45 | March 14th 06 11:36 PM |
| Hole Finder | [email protected] | Home Built | 2 | March 6th 06 02:32 PM |
| Rubber Bushing Replacement | Boelkowj | Home Built | 8 | December 12th 03 12:45 AM |
Threaded Mode