|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
September 28th 07, 10:11 PM
posted to rec.aviation.owning
|
|||
|
|||
Voltage, EDM-700, trim switch follow-up
A wing mounting for the oat probe is good. I don't know what they
were thinking, but whoever installed mine (came with the plane) put it under the belly where it catches engine exhaust. It's not seriously in error except on the ground, but I may elect next annual to have it moved. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Voltage variation | Jay Honeck | Owning | 18 | October 3rd 07 09:05 PM |
| Electric trim switch -- source? | Jay Honeck | Owning | 19 | August 1st 07 02:06 AM |
| Mooney Low Voltage | [email protected] | Owning | 22 | August 1st 05 01:01 PM |
| FA: 12V to 24V DC voltage converter | Karl Geng, N1DL | Home Built | 2 | April 21st 05 08:48 PM |
| Remote Switch for Pointer ELT --- Why Does It Need Voltage? | jls | Home Built | 1 | November 22nd 04 09:13 PM |
Threaded Mode