![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]()
All,
Thanks for your inputs. The trailer is a "Swan", which is a clamshell, fiberglass top, trailer that looks a bit like an older Cobra or Komet. The only place I think they could get in is at the rear where the top comes down on the tailgate. Not sure if that is a tight, i.e., smaller than a mouse, seal or not. If that is the opening, I'll have to see what can be done to make it tighter. Don't think hardware cloth is the answer in this case. While I do enjoy the new trailer, I guess it has a fault: It makes a nice mouse home. While my old trailer had several faults, I can't blame it for attracting rodents. Heck, it probably repelled them with its sheer ugliness. Since it wasn't very weather tight, with large gaps between the rear (and only) door and the trailer frame, and could have allowed LARGE critters in, I'm kind of surprised this never happened when I had that trailer. Guess it was too ugly outside and too cold inside. I guess the little furries didn't find it as attractive as the nice new Swan. Wish I could live where the trailer could stay inside a nice building and my wife's pets could keep the unwanted critters at bay. But it stays tied down outside. Thanks, Ray |
Thread Tools | |
Display Modes | |
|
|