|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
February 19th 08, 10:37 AM
posted to rec.aviation.soaring
|
|||
|
|||
Turn and Bank indicator and competition
AK wrote:
The question is; do I have to remove the instrument all together or can the competition director seal the switch in off position or cover the instrument and seal it? I've seen installations with long screws where a cover could be mounted and sealed. (Long screws for the cover and wing nuts with a hole for the sealng wire.) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bank/turn indicator instrument question | Bruce W.1 | Home Built | 10 | February 17th 05 04:14 PM |
| Turn & Bank Indicator and 2 gallons of poyester resin | [email protected] | Aviation Marketplace | 1 | February 14th 05 06:36 PM |
| Turn & Bank Indicator and 2 gallons of poyester resin | [email protected] | Piloting | 0 | February 12th 05 07:53 PM |
| Turn & Bank Indicator and 2 gallons of poyester resin | [email protected] | Instrument Flight Rules | 0 | February 12th 05 07:52 PM |
| Turn & Bank Indicator and 2 gallons of poyester resin | [email protected] | Home Built | 0 | February 12th 05 07:50 PM |
Threaded Mode