|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 21st 08, 04:16 PM
posted to rec.aviation.soaring
|
|||
|
|||
Ventus cM turbulators
I need to replace my zig-zags on the horizontal stabilizer, but I would need
to know the required position cordwise (upper and lower surface). I took it off and cleaned before having a look at the maintainace manual - which does not give any info on the topic... :-( Any ideas ? Bert TW 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbulators | David Gould | Soaring | 7 | August 10th 05 11:34 PM |
| Nimbus 3 turbulators | [email protected] | Soaring | 3 | December 8th 04 10:05 PM |
| Turbulators and DG-101 | John DeRosa Sky Soaring Chicago IL | Soaring | 2 | February 25th 04 05:41 PM |
| Turbulators on Club-Libelle | Christoph Barniske | Soaring | 9 | January 22nd 04 06:50 PM |
| Tailplane/elevator turbulators | Ronald E Baker | Soaring | 0 | November 9th 03 09:49 AM |
Threaded Mode