![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#16
|
|||
|
|||
![]() "Beryl" wrote in message ... wrote: On Feb 25, 10:58 pm, flybynightkarmarepair wrote: I've since heard from Veeduber (who knew Pazmany, and flew out of the same airport as the prototype) that you could smell the first ship before you could see it, as it burned, errr flew off the first 40 hours with the belts constantly slipping. ------------------------------------------------------------------ Well... mebbe it wasn't quite that bad... :-) But with multiple vee belts it's impossible to keep ALL of them at the same tension. The loosest of them would slip and there was a definite pong of hot rubber after every flight. Eh? I can't visualize it. Either all, or none, slip. I must admit that I am having a little trouble visualizing this one as well--unless that loosest belt was either the farthest from the engine or the farthest from the prop. In those cases, I have no trouble at all. Peter |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pazmany PL4 | (Keith Sowter) | Piloting | 3 | February 25th 08 04:19 AM |
FREE - Homebuilt project - Pazmany PL1 | Eugene Wendland | Home Built | 1 | June 22nd 07 04:06 PM |
Pazmany pL2 plans | frank connaly | Home Built | 10 | November 16th 06 11:36 AM |
Pazmany PL2 strut leak | moni nut | Home Built | 1 | April 27th 04 02:24 AM |
Any Pazmany PL-1/PL-2 owners out there... | Gene Z. Ragan | Home Built | 3 | March 6th 04 04:39 AM |