![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#18
|
|||
|
|||
![]()
"skym" wrote in message
... While making a turn to base and final recently, I was aware that I was going to be wide with my normal turn from downwind through base to final, so I banked more to keep as close to the runway centerline as possible. I kept thinking about the infamous and usually fatal stall/ spin by some pilots in this situation, I kept thinking that if I keep the ball centered, even with a very steep bank, that I would be ok and not auger in. Some of you instructors and old pros...is this correct? (Not that I intend to make it a practice.) Instead of asking about keeping the ball centered, perhaps you should be asking why you elected to flirt with a pilot error fatality by cranking and yanking for the sake of a few style points... So what if you overshoot the turn???? Note: as others are beating to death - stall speed doesn't change with bank. Stall speed changes with increasing G (increasing lift). Increasing G comes from pulling on the yoke/stick. Period. No pull, no G, no increase in stall. More pull, more G, higher stall. Wings level, wings banked, wings upside down - makes no difference. -- Geoff The Sea Hawk at Wow Way d0t Com remove spaces and make the obvious substitutions to reply by mail When immigration is outlawed, only outlaws will immigrate. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Implications of.....keeping the speed up | [email protected] | Instrument Flight Rules | 48 | January 14th 07 11:41 PM |
Gamepad, stopping throttle axis from being auto-centered | DenisK | Simulators | 1 | December 20th 06 09:16 AM |
Keeping a builders log | Lou | Home Built | 24 | January 28th 06 10:46 PM |
Thanks for ideas on drilling a centered hole! | Scott | Home Built | 12 | October 25th 04 02:52 AM |
Keeping Me Out of Your Warbird? | Stephen Harding | Military Aviation | 47 | February 12th 04 04:34 PM |