![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]()
On Apr 1, 8:19 am, Dan wrote:
On Apr 1, 12:06 pm, "Ken S. Tucker" wrote: On Mar 31, 11:02 pm, "Private" wrote: "Private" wrote in message ... Piper Malibu down east of Edmonton 5 sob FYI http://news.google.ca/nwshp?hl=en&ta...577933&topic=h http://discussions.flightaware.com/v...?p=47890#47890 http://www.aviation.ca/component/opt...temid,306/func... Condolences to family & friends. http://www.ctv.ca/servlet/ArticleNew...80329/alta_pla... http://news.google.ca/nwshp?hl=en&ta...577933&topic=n This is news to me,http://www.canada.com/edmontonjourna...d=1c6483cc-309... So in IFR in dense cloud, the AH starts going funny, one still x-checks against the heading indicator and the altimeter/rate of descent. Finally there's the magnetic compass that is fool- proof, (not idiot proof-Bertie couldn't find it ;-). For rate of descent, the power setting vs, KIAS gives a fair good idea of the rate of descent. That all works for a 1/2 ass pilot, however if the cabin pressure had a slow leak, and the pilot slowly looses mental faculties, (Bertie is a typical example), that could lead to pilot confusion. Ken And the last time you flew partial panel in IMC was....? I was blind-folded, and the instruments were in Brail. That excersize was conducted at night in clouds with total electrical failure. To play it safe I did an extended flare over the numbers, that's because I had two dead jet engines and had to dead stick without flaps, SOP. How about you Dan? Ken |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
All this Barron Thomas stuff | xyzzy | Owning | 7 | September 9th 05 03:13 AM |
Thomas Roberts | Udo Rumpf | Soaring | 0 | February 29th 04 12:24 AM |