![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]() wrote in message ... On Apr 11, 7:55 am, "RST Engineering" wrote: You sell too cheap, Bob. I've already made the arrangements that mine will (((snipped a bunch))) means they're second-raters. Progress comes from tackling the chores everyone says are IMPOSSIBLE. -Bob Bob, if you think nothing is impossible, (as I read somewhere on the internet last week), please try SLAMMING A REVOLVING DOOR ! Sorry, Pal. I just had to throw that one in there. The kit I made in 1962 finally went away in my last move to smaller quarters. It did heroic service from then to 2005. The casters were replaced once, and the drawers were upgraded in 1968 to plexiglass, but everything else including the alkyd enamel inside and out stood well. Even the YESCO (Young Electric Sign Co, Las Vegas, 1963) decal remained. Flash |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Whats in YOUR toolbox? | Travis Beach | Soaring | 8 | October 25th 06 06:17 PM |
Whats in YOUR toolbox? | Travis Beach | Soaring | 12 | October 22nd 06 06:55 PM |
Mechanics Toolbox | Stache | Piloting | 0 | October 13th 06 04:16 AM |
FS: Snap-on aviation style toolbox | mike | Home Built | 0 | October 18th 03 07:27 PM |
FS: Aviation toolbox Snap-on KR-562 | mike | Aviation Marketplace | 0 | October 17th 03 02:45 AM |