![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#19
|
|||
|
|||
![]()
Big John wrote:
See the step but don't remember ever seeing on the original plan/birds????? which I looked at years ago for possibility of building. May have missed that minor detail. The step on my Long EZ is per plans. I don't know what kind of step the Varieze plans called for, if any. Maybe someone with a Varieze could chime in. I'd like to know. The EZ had a carnard/rain problem. Is that fixed now or do you have to fly around the problem? Well, it's not fixed on my airplane. If I want to fix it, I have to build a new canard. The effect can be trimmed out. Variable rain requires frequent re-trimming, of course. I largely avoid flying in the rain because of my wood prop. Interestingly, the canard will let me know it's raining even when the rain is so light that I can't see it. It's my drizzle/virga detection system. g On several occasions it has clued me in to virga that I would have been oblivious to otherwise. Have seen lots of figures. What's your HONEST cruise at say 8K? I get 162 kt TAS at 8,500 full throttle leaned for best power. The engine is a 150 hp O-320. I have wheel pants in the hangar that would give me another 5 kt or so if I would only install them. g Plus there are a number of other things I could do to clean it up aerodynamically. Interestingly, the boarding step alone knocks close to 1 kt off the top end. Regards, David O -- http://www.AirplaneZone.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
wing root strakes (not canard A/C) | Wallace Berry | Home Built | 0 | October 2nd 03 08:47 PM |
question about EZRocket | David O | Home Built | 6 | October 1st 03 06:03 PM |
virgins (was: Question - Regarding Canard Pushers...) | RobertR237 | Home Built | 1 | August 10th 03 11:06 PM |
Question - Regarding Canard Pushers... | Tilt | Home Built | 33 | August 10th 03 11:07 AM |
Canard static port location | Paul Lee | Home Built | 1 | July 12th 03 02:55 AM |