![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#7
|
|||
|
|||
![]()
wrote in message
... On Aug 14, 1:00 pm, passenger 1957 wrote: There's a tooth missing. The ring gear should be replaced at overhaul. If there's a tooth missing, it's likely pretty old, or the starter had engagement issues. It should be engaging the ring gear promptly, before the starter really winds up, and if the starter drive is sticky the teeth will get worn quickly. On a four-banger there are two places on the gear that get it the most, both where the prop tends to stop on shutdown. The drive bendix on a Lyc needs lubing with silicone spray lube, and it's really hard to get at. Any other lubricant will attract dust and create a sticky sludge that sooner or later causes engagement problems, tearing up the ring gear, and then seizes the drive splines and the starter won't engage at all. Many starters (and batteries) get replaced unnecessarily because the solenoids are old and their contacts are corroded or burned. Any resistance across those contacts causes a large voltage drop because of the high current flow, and it can be verified using a voltmeter across the studs while cranking. There shouldn't be more than a volt or so of drop. Both the master and starter solenoids should get replaced if this is noted. Some pilots just keep cranking if the engine is flooded or cold or has a bad mag or whatever else is making it reluctant to start. Good way to bust a starter. Lycoming recommends something like a ten-minute cooldown after three ten-second cranks. Starters have no cooling system and use a tremendous amount of current that generates a lot of heat.The commutator segments are set in plastic which overheats and throws the segments, and the field and armature windings get hot and burn off their insulating varnish and short together. Things really get hot then. Killing a battery with the starter will often ruin it permanently; I don't know how many batteries we've replaced after someone ground them right down, sulfating them so bad they wouldn't take a charge anymore. Got to think, Pilot: why won't it start? What should I do besides just cranking and hoping for a miracle? Dan Well said. The definition of stupidity is doing the same thing over and over again and expecting different results. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dust Devil 2005 - South African National Gliding Championships 2005 | [email protected] | Soaring | 0 | December 27th 05 09:20 AM |
Starter | Denny | Owning | 6 | September 27th 05 10:32 PM |
C-150 (O-200) Starter | Dave | Home Built | 0 | November 25th 04 10:57 AM |
C-150 (O-200) Starter | Dave | Restoration | 0 | November 25th 04 10:57 AM |
Starter Questions | Aaron Coolidge | Owning | 4 | June 30th 04 02:52 PM |