![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]() Bill Daniels wrote: As for sound as an airspeed cue, the glider I fly is quiet enough the ASI is needed for accurate speed control. The air noise seems mainly a matter of a good canopy seal. Is there a good sealing material that anyone has found? I've tried commercial foam strip, but it's rather too thick, and smears to a gummy mess after a while. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question: Standard rate turns, constant rate turns, and airspeed | Robert Barker | Piloting | 5 | April 15th 07 04:47 PM |
My weird sink drain | AES | Piloting | 11 | April 13th 06 10:17 AM |
will the CBS forgeries sink Kerry? | Cub Driver | Military Aviation | 3 | September 14th 04 12:12 AM |
Rounding a turnpoint in sink | CV | Soaring | 13 | July 22nd 04 05:27 PM |