![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#5
|
|||
|
|||
![]()
On Feb 5, 9:20*pm, Brian Whatcott wrote:
bildan wrote: .... I've looked at the ducted fan issue and it looks like they can be optimized to produce 8 -10 Lbs of thrust per HP in the 80 knot speed range. *The only airplane I know of that would benefit from that is a glider tug. 9 lb of thrust at 60 kt takes 1.6 HP Perhaps you had 30 kts in mind for 9 lb thrust per HP at 80% efficiency? Brian W Yeah, that sounds about right. I was looking at the acceleration of a glider being towed. A glider tug is one of the few airplanes where the 0 - 60 acceleration time matters since you have to get the glider up to an airspeed where the ailerons are effective enough to balance on a single wheel. 30 knots is in the middle of that range. A glider tug looks like a nearly perfect application for a ducted fan. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
info | sierra | Soaring | 3 | January 2nd 07 03:24 AM |
Info please | ASM | Soaring | 7 | October 21st 06 02:41 PM |
RHJ-8 Info? | Scott | Soaring | 6 | March 24th 05 09:21 PM |
POSA Carb Info and HAPI Engine Info | Bill | Home Built | 0 | March 8th 04 08:23 PM |
Starting new info site need info from the pros | MRQB | Piloting | 7 | January 5th 04 03:20 AM |