|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#18
February 17th 09, 02:41 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Aviation Sheetmetal Work
On Feb 16, 6:07*pm, Anthony W wrote:
Brian Whatcott wrote: Brian W Try a 50/50 mix of automatic transmission fluid and kerosene. *You will be amazed how well it both lubes and protects against rust. Tony If anything is siezed the auto trans fluid will free it up quick. In addition to removing paing it also likes to clean up rust. Joe S. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Marking sheetmetal | Michael Horowitz | Home Built | 41 | September 23rd 06 05:25 PM |
| Conservative friends of aviation at work | Paul Tomblin | Instrument Flight Rules | 2 | April 30th 05 04:30 PM |
| Did your ELT work? | Eric Greenwell | Soaring | 11 | June 24th 04 02:45 PM |
| where's the THRILL is flying, rec.aviation.balloon, rec.aviation.hang-gliding, rec.aviation.powerchutes, rec.aviation.soaring | BW | Rotorcraft | 0 | October 15th 03 11:42 AM |
Threaded Mode