Vertical stabilizer wont come out (Asw-19)

On May 26, 10:44*am, wrote:
- We've wrapped a wire behind the vertical bar that carries the attach
pins and two other friends were pulling forward on the sides of the
stab; I, in return, was pounding *with a hammer on the locking hex
screw that normally locks down the stab. The stab had not even moved a
millimeter... According to a Schleicher Engineer we can knock one of
the pin out, from inside, if we remove the rudder... Maybe the
electrical wire freeze will work, although from Physics it should
shrink the subjected metal and heating should expand it.

Thanks

Gregg- Hide quoted text -

- Show quoted text -


Maybe I'm over conservative but I would never pound on that bolt with
a hammer. I'd also be very careful about using any significant force
on the end of the exposed pin. If that one moves and the other is
stuck you will just make it bind up tighter.

If it went together and it has not been together long enough to
corrode it should come apart. Gettting the alignment just right to
find the sweet spot will be the key. Brute force is very unlikely to
help.

Good luck

Andy