A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Soaring
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Winch Launch Fatality



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old June 23rd 09, 04:14 PM posted to rec.aviation.soaring
Martin Gregorie[_5_]
external usenet poster
 
Posts: 1,224
Default Winch Launch Fatality

On Tue, 23 Jun 2009 06:24:24 -0700, bildan wrote:

On Jun 23, 4:34Â*am, John Smith wrote:
ucsdcpc wrote:
The routine we are taught is as follows, all part of the pre-flight
eventualities check before each launch:


1. Â* Â*decide on appropriate approach speed for conditions


2. Â* Â*in the event of a launch failure (not just cable brake) lower
the nose to an appropriate attitude


Wrong, very wrong, very dangerous. The correct sequence is:

1. Push the stick forward and pull the release knob.

2. If possible, land ahead on the remaining runway.

3. If you're too high to land ahead, you have all the time to decide
your further actions. This can be an abbreviated circuit or a downwind
landing, depending on the circumstances.

And yes, doing a 180 too hasty will put you in a situation where you
don't have enough runway to land. So whatever you do, don't panic.
Everything else depends.


Please explain why pulling the release is priority one.

Apart from anything else, your hand should be on the release knob during
the launch, so pulling it a couple of times immediately after pushing
over and just before letting go of it is an obvious move. That is taught
as SOP in my club.

Most likely the
remaining rope and parachute gear has already back released.

..... only if the cable break was down near the winch. If the break was
near the glider you could still have several meters of cable and the
furled drogue dangling trailing from the hook. Its even more likely that
you'll still have the cable attached if the problem is a power fade at
the winch rather than a cable break.


Diverting attention to the release knob when other critical decisions
are pending seems odd when you think about it.

It should be in your hand already, so no attention diversion is needed.

Note to Schweizer operators: Schweizer CG hooks require MUCH more force
to back release than the Tost release so you folks should pull.

There's the other answer: never train somebody to use a technique that is
unsafe on some types of glider. Murphy pretty much mandates they'll
forget to check the cable is gone when they're flying a type where it
matters.


--
martin@ | Martin Gregorie
gregorie. | Essex, UK
org |
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Pay out winch launch to 2500ft agl.. WAVEGURU Soaring 8 June 5th 07 07:06 AM
Winch Launch Videos Mike Schumann Soaring 2 January 19th 06 11:27 PM
LIppmann reports a 950 meter winch launch with their Dynatec winch line - anything higher? Bill Daniels Soaring 20 December 27th 04 12:33 AM
Electric winch fatality story in August Soaring Bill Daniels Soaring 0 August 14th 04 02:37 AM
Winch launch M B Soaring 0 October 30th 03 07:33 PM


All times are GMT +1. The time now is 08:46 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.