If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#15
|
|||
|
|||
Home machining
Anthony W wrote:
Flash wrote: Lately the signal to noise ratio has gone sour, but rec,crafts.metalworking has been pretty fair, too. Lots of knowledgeable people still there, but an increasing number of cross-posters dump on it, too. Just have to look and ignore some threads, posters. Flash I tried that group for a few day and I found it not worth the insanity... Tony There are about 6 guys that have to be filtered out. Then it gets back to usable... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The Home-made Home-builders Engine | Veeduber[_2_] | Home Built | 37 | June 12th 09 04:22 AM |
F-111 comes home | Don Pyeatt | Aviation Photos | 1 | May 5th 08 11:26 PM |
Foamy's Home Away From Home | Michael Baldwin, Bruce | Products | 0 | December 22nd 06 11:14 AM |
Exclusive Custom Home Plans, and Essential information about building your New Home | orange tree | Home Built | 4 | November 20th 05 04:37 PM |
Welcome Home | Meade Spotts | Naval Aviation | 0 | March 11th 04 01:17 AM |