|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
September 19th 09, 09:34 PM
posted to rec.aviation.soaring
|
|||
|
|||
removing transparency coating
On Sep 19, 11:44*am, wrote:
http://home.hiwaay.net/~langford/kcf.html Look at this link towards the bottom of the page. *It has some good details on getting rid of the film covering. Hey, guess what? Hot water works, I just poured boiling water over a K-6 canopy that must be 30 years old. The protective covering was hard as a rock. Boiling water made it soft and rubbery and I was able to get one side started and then peal the whole covering off. Anyone need a K-6 canopy? Also have 2 open Cirrus forward canopies and a blue rear Cirrus canopy (mounted). and a Minstrel canopy, all with rock hard protective covering that we now know how to remove. JJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Penalitel anit-corrosion coating | Jon Woellhaf | Owning | 2 | June 27th 07 06:11 PM |
| Coating aluminum | Lou | Home Built | 23 | December 24th 05 04:11 AM |
| How to identify fabric/coating process used? | Wallace Berry | Home Built | 7 | October 7th 05 07:14 PM |
| Doors Open On New Powder Coating Facility Anaheim California United States | [email protected] | Home Built | 0 | October 21st 04 02:33 PM |
| Suitable coating for spring-steel wire? | Wright1902Glider | Home Built | 6 | February 9th 04 04:12 PM |
Threaded Mode