|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
November 18th 09, 11:35 PM
posted to rec.aviation.soaring
|
|||
|
|||
Gelcoat repair
The process is very messy and can be hazardous to your health. And it takes many, many hours of careful preperation. Labor intensive. As JJ said, mass balance of controls is very important. 400-1000 hours is possible...no joke. Polyurethane may be best way to go. GA 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Source for Gelcoat in USA? | John Bojack[_2_] | Soaring | 1 | June 9th 09 05:25 AM |
| Gelcoat sag? | [email protected] | Soaring | 10 | December 17th 07 08:07 PM |
| Fiberglass/gelcoat repair question | Kilo Charlie | Soaring | 9 | April 19th 05 03:30 PM |
| Ferro gelcoat | Basil Fairston | Soaring | 0 | December 16th 03 08:34 AM |
| Refinishing gelcoat | tango4 | Soaring | 21 | November 3rd 03 07:29 AM |
Threaded Mode