![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#12
|
|||
|
|||
![]()
In article ,
Scott wrote: Alan Baker wrote: In article , Ed wrote: On Sat, 28 Nov 2009 19:07:16 -0600, brian whatcott wrote: Stealth Pilot wrote: /snip/ it is the air below pushing you up that lifts the wing. Stealth Pilot In most circumstances, suction on the upper surface contributes about 2/3 rds of the lift, and pressure on the lower surface contributes about 1/3 rd. That's one reason which rib stitching for rag wings is a biggy. Brian W I have never noticed the fabric lifting on my wings, however I have seen the fuel siphon out of a wing tank due to an improperly applied fuel cap. And greater pressure in the tank than outside of it... Right, but in a sealed metal tank, is all that other fuel PUSHING the fuel out of the vent since air can't PULL it out? First of all, the tank is not completely sealed. If it were, the fuel pumps would soon have difficult pumping the fuel out of the tank. So, yes, the greater pressure inside the tank is pushing the fuel out. -- Alan Baker Vancouver, British Columbia http://gallery.me.com/alangbaker/100008/DSCF0162/web.jpg |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure Distribution Charts | sisu1a | Soaring | 0 | September 21st 08 05:53 PM |
Soundwaves Boost Wing Lift | [email protected] | Home Built | 30 | September 5th 05 10:21 PM |
747 weight distribution | Robin | General Aviation | 25 | June 22nd 05 03:53 AM |
Distribution of armor on a B-52 | B2431 | Military Aviation | 12 | August 16th 04 09:07 PM |
Alternator load distribution in a Baron | Viperdoc | Owning | 7 | December 9th 03 10:27 PM |