![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
Alan Baker wrote:
In article , Beryl wrote: Alan Baker wrote: In article , Jim Logajan wrote: You must have a devil of a time figuring out what keeps balloons afloat, what with no handy downward moving air! I have no trouble figuring that out at all. A gas of a different density within the balloon causes the net upward force on the balloon exerted by the air outside the balloon to be greater than the net downward force on it. Nope! The "gas of a different density" inside does not cause the differential forces exerted by the air outside. Whether the balloon is filled with phlogiston or concrete, the difference between upward and downward forces exerted by the air outside depends on the height of the balloon. That's what my goofy 10,000 foot thick wing was, that would take off with no airspeed or power. A balloon. You're wrong. The "net downward force" includes the force of gravity. Which is lessened because a gas of lower density.. ...I can't believe I have to explain things so basic. I know, but you have to. Your first attempt didn't appear to include unsaid gravity. Gas that you described as "within the balloon" is now treated as "part of" the balloon. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure Distribution Charts | sisu1a | Soaring | 0 | September 21st 08 05:53 PM |
Soundwaves Boost Wing Lift | [email protected] | Home Built | 30 | September 5th 05 10:21 PM |
747 weight distribution | Robin | General Aviation | 25 | June 22nd 05 03:53 AM |
Distribution of armor on a B-52 | B2431 | Military Aviation | 12 | August 16th 04 09:07 PM |
Alternator load distribution in a Baron | Viperdoc | Owning | 7 | December 9th 03 10:27 PM |