|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
February 6th 10, 10:31 PM
posted to rec.aviation.soaring
|
|||
|
|||
Gel coat removal - water sanding vs. straight line sanding
On Feb 6, 2:23*pm, Steve Leonard wrote:
On Feb 6, 3:56*pm, LS3 Pilot wrote: Well, specifically, what about this one? http://www.google.com/products/catal...en&show=dd&cid... Sand dry. Use a vacuum of some sort if you want to try and keep dust in the area to a minimum. *Didn't want to hear that either, did you? Steve One of more than a few reasons I don't do it for a living anymore. Craig 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sanding of plywood before epoxy | [email protected] | Home Built | 6 | July 15th 08 01:21 PM |
| Sanding or Waxing - PIK 20 Question | culverflyer | Soaring | 22 | September 22nd 05 09:01 PM |
| Advice on sanding fibreglass | [email protected] | Home Built | 12 | April 28th 05 10:39 PM |
| Sanding composites | [email protected] | Home Built | 12 | January 31st 05 06:47 AM |
| Fear of Sanding | Stuart Grant | Soaring | 7 | January 17th 05 05:28 PM |
Threaded Mode