![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I was trying to work out the expected height gain from a pull up
Experienced glider pilots say you will get a better pull up with a heavier glider / water etc. But I can't see this from my (probably incomplete) equations: total energy = potential energy + kinetic energy total energy before pull up = total energy after pull up m * g * h0 + m * pow(v0, 2) * 0.5 == m * g * h1 + m * pow(v1, 2) * 0.5 with h0 v0 being height and speed before pull up and h1 v1 being height and speed after pull up mass cancels out of this equation I think I need to include momentum in there somehow? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Physics Quiz Question | Dallas | Piloting | 28 | August 14th 07 02:02 AM |
Pull up a chair and hear me out: | Vaughn | Aviation Marketplace | 0 | February 2nd 06 02:04 AM |
Physics question | Rich S. | Home Built | 62 | September 14th 05 02:05 PM |
Question about center-line push-pull engine configuration | Shin Gou | Home Built | 4 | June 7th 04 05:57 PM |
Glider pull-up and ballast | M B | Soaring | 0 | September 15th 03 06:29 PM |