![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#23
|
|||
|
|||
![]()
Inspection was done on our Blahnik this afternoon....
Our Blahnik has a low number of flight...ie. only 1200 hours with 1750 starts. No acrobatics flight except a few rare loopings... Always aerotowed...No winch launches... Inspection with eyes and bright light showed nothing. We took pictures wtih a small digital cam equipped with a flash (small Olympus one). When we uploaded the pictures on the PC, we carefully looked at the pictures and we saw ...longs thin cracks... With the eyes it was impossible to detect due to the fact that the available room for inspection is very limited.... We spoke in the previous post about fatigue....well, I am deeply convinced that our Blahnik has never been "fatigued".... The cracks seems to be produced because the rivet from which the cracks are born, has been installed by a hand process during the manufacturing. The manual process for installing these rivets is clear on the picture I took. I strongly suspect a poorly manual manufacturing process instead of a fatigue problem. I am really upset to discover this problem now especially that there is no repair procedure nor a replacement procedure. The AD just states that the Blanik is grounded. This is unacceptable |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blanik L-23 Super Blanik Manual -F.C.F.S. | Joel Flamenbaum | Soaring | 2 | April 14th 10 03:29 PM |
Mandatory ELT | [email protected] | Soaring | 9 | March 8th 05 03:01 PM |
ELT Mandatory ? | Jim Culp | Soaring | 20 | June 19th 04 06:40 PM |
New security bulletin | gatt | Piloting | 28 | June 9th 04 10:33 PM |
Grob 103 bulletin becomes AD | Mike Borgelt | Soaring | 0 | October 3rd 03 12:47 AM |