![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#5
|
|||
|
|||
![]()
Last time I measured--a while ago, the smallest floor jack (on wheels) from
NAPA auto parts would have fit but for machining one bushing. Simple job but I didn't have a lathe then,. I was going to take it back for a refund, but I decided to keep the jack. It was about the same price as the replacement part anyway. I would have saved a few bucks, and the shipping. -- Hartley Falbaum "noel.wade" wrote in message ... Not to hijack your thread Jacek, but I was just about to post regarding my Cobra trailer... The fuselage-ramp scissor-jacks just failed (stripped thread, then the bearing failed under the resulting load). I've seen some older postings about these jacks but does anyone have an up-to-date source for small scissor jacks that would fit? Most retail-store jacks are too big, and I'm willing to bet that if I go direct to Cobra or one of the glider mfgrs/dealers that it'll cost me a bundle. Thanks, --Noel |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
COBRA TRAILER | Gordon Schubert[_2_] | Soaring | 0 | February 10th 09 04:15 AM |
WTB: Cobra Trailer for LS-4 | [email protected] | Soaring | 0 | July 31st 08 05:04 PM |
Cobra Trailer | [email protected] | Soaring | 22 | December 7th 06 11:38 PM |
Cobra Trailer | Soaring | 1 | September 28th 03 01:14 PM | |
FS: Cobra Trailer | Ed Byars | Soaring | 0 | September 22nd 03 04:47 PM |