V-8 powered Seabee

On Thu, 30 Oct 2003 12:45:26 GMT, "Eric Miller"
wrote:

"Barnyard BOb --" wrote in message
.. .

Some years ago a company was building Ford engines for installation in
homebuilts. They did a couple of experiments of running the engine, with
a prop, without coolant. On both occasions the broken-in engines ran for
30+ minutes. Both stopped due to expansion of the pistons in the bores.
When the engines cooled the coolant systems were filled and the engines
started. Both ran and turned the prop at the same rpm. But also both
engine's head gaskets were shot and the metallurgy of both the heads and
the pistons had changed to the point of all having to be relegated to
the scrap pile. Crank and rod bearings were still in good condition.

Bruce A. Frank
++++++++++++++++++++++++++++++++++++++++++

What RPM?
What power level?

Unless producing realistic in-flight power....
is there value in this exercise beyond PR?


Barnyard BOb --

What PR? As I read it, if you're cooling system fails you basically have
enough time to set it down then you're looking at a new engine.

Eric

So far, I've not read of any reported catastrophic coolant losses in
the Ford powered airplanes. There have been instances (I've read of
two in Bruce's newletter) in which the head gasket began leaking.
This resulted in pressure readings that were abnormal, and the pilots
in both instances noticed them.

The airplanes were flown back to their home fields and the head
gaskets were replaced. In one instance, the airplane was a fair
distance from the field. Inflight coolant temperatures did not change
much, it was the pressure when the engine was shut down that got the
pilot's attention.

When you think about it, where where might a catastrophic leak occur
and how? Could a hose burst? A hole develop in the radiator? Those
things normally don't just blow up and spew out everything, they leak
very slowly at first, and a thorough preflight should include looking
for signs of coolant leakage I'd think.

When you put together a water cooled auto conversion, you use premium
hoses and radiators, right? You don't install aged and hardened parts
do you? Well I'm not going to anyway.

Corky Scott