![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#16
|
|||
|
|||
![]() Some years ago a company was building Ford engines for installation in homebuilts. They did a couple of experiments of running the engine, with a prop, without coolant. On both occasions the broken-in engines ran for 30+ minutes. Both stopped due to expansion of the pistons in the bores. When the engines cooled the coolant systems were filled and the engines started. Both ran and turned the prop at the same rpm. But also both engine's head gaskets were shot and the metallurgy of both the heads and the pistons had changed to the point of all having to be relegated to the scrap pile. Crank and rod bearings were still in good condition. Bruce A. Frank ++++++++++++++++++++++++++++++++++++++++++ What RPM? What power level? Unless producing realistic in-flight power.... is there value in this exercise beyond PR? Barnyard BOb -- What PR? As I read it, if you're cooling system fails you basically have enough time to set it down then you're looking at a new engine. Eric +++++++++++++++++++++++++++++++++++++++++ I sincerely and most humbly apologize. My generosity was aimed to cut these defunct folks some slack. However, I have no problem seeing it your way. g Barnyard BOb -- |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
human powered flight | patrick timony | Home Built | 10 | September 16th 03 03:38 AM |
Illusive elastic powered Ornithopter | Mike Hindle | Home Built | 6 | September 15th 03 03:32 PM |
Pre-Rotator Powered by Compressed Air? | nuke | Home Built | 8 | July 30th 03 12:36 PM |
Powered Parachute Plans | MJC | Home Built | 4 | July 15th 03 07:29 PM |
Powered Parachute Plans- correction | Cy Galley | Home Built | 0 | July 11th 03 03:43 AM |