|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
July 27th 11, 08:07 AM
posted to rec.aviation.soaring
|
|||
|
|||
XCSoar - Portrait / Landscape
I have a sinilar problem.
The relevant "Display Orientation" option is available when XCSoar runs on my Ipaq 3870 (Where I don't need it!), but not on my PNA (WayTeq x950), where I *do* need it. Anyone know why? Is there a solution? Regards Kevin On Jul 25, 11:35*am, Peter Scholz wrote: This is possible with XCSoar 6.1, earlier versions probably not. HowTo: Config System Setup 18 Interface Appearance Display Orientation: Default | Portrait | Landscape -- Peter Scholz ASW24 JE 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [07/10] - 10 Ubiquitous Self Portrait.JPG (1/1) Part 7 - last | Waldo.Pepper[_2_] | Aviation Photos | 0 | September 16th 08 03:29 AM |
| Air Force Family Portrait 1958 | Paul Laughlin | Aviation Photos | 14 | October 30th 07 06:13 PM |
| Air Force VFamily Portrait 1958 | Paul Laughlin | Aviation Photos | 10 | October 17th 07 08:11 AM |
| Mercury - portrait ot original 7 s62_8774.jpg | [email protected] | Aviation Photos | 0 | April 10th 07 02:56 PM |
| Lago Terramesh 13 (England & Wales) - holes in landscape? | Kevin Reilly | Simulators | 3 | November 11th 03 02:46 PM |
Threaded Mode