|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
November 7th 03, 03:15 PM
|
|||
|
|||
"Ron Natalie" wrote in message
... Unless you were previously filling your tires with helium, there isn't much to be gained on diffusion by this change. But using helium filled tires ensures squeaky landings! I suppose you can use grease filled tires too, but it's a lot heavier and not good for the rubber. =D Eric 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Manifold pressure gauge problem | Dave Russell | Aerobatics | 3 | January 29th 04 03:46 AM |
| Nosewheel Shimmy and Scalloped Tire Redux, Plus | Larry Smith | Home Built | 2 | September 15th 03 04:03 PM |
| Scalloped Nosewheel Tire | Larry Smith | Home Built | 7 | September 12th 03 09:16 PM |
| Fuel pressure Problems | smf | Home Built | 3 | September 7th 03 08:25 PM |
| Pressure Differential in heat Exchangers | Bruce A. Frank | Home Built | 4 | July 3rd 03 05:18 AM |
Threaded Mode