|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#18
November 12th 03, 01:45 AM
|
|||
|
|||
"Michael Horowitz" wrote in message ... I'd be interested in any schemes you may have developed for pre-heating your engine. One idea I heard was to use flex ducting to direct car exhaust into the cowling; that does present CO concerns, but on could leave the a/c doors open. - Mike Try starting your car, and feeling the temp at the end of the exhaust pipe. Not too warm. Add to that, the volume is very low, compared to commercial rapid pre-heaters. Good attempt, but try again, IMHO. -- Jim in NC 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode