|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
June 19th 12, 03:35 PM
posted to rec.aviation.soaring
|
|||
|
|||
Winscore finish cylinder setup
On Tuesday, June 19, 2012 5:07:12 AM UTC-7, kirk.stant wrote:
I'm learning how to setup Winscore for a local club fun contest. So far it makes sense, but setting up the Finish Cylinder is a bit confusing. How do I set it up for a 500' agl min finish height? The finish settings have settings for the Top and Base of the Finish Gate Cylinder, both in ft MSL. Kirk 66 Kirk, You may want to consider a finish cylinder base at 700AGL/1sm + 200'/sm if bigger. You do not want to tempt someone to start thermalling at 300' at the edge of the cylinder so they get a speed finish. QT QT 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2011 WINSCORE | Ron Gleason | Soaring | 9 | April 21st 11 03:11 AM |
| WinScore help | Spam | Soaring | 2 | September 6th 09 04:00 PM |
| How to add an IGC validation DLL to Winscore ? | Dave Nadler | Soaring | 1 | June 18th 09 07:22 PM |
| How does Winscore calculate finish altitude? | kirk.stant | Soaring | 46 | July 31st 07 07:38 PM |
| Visulalizing the Finish Cylinder | [email protected] | Soaring | 44 | March 25th 05 02:10 PM |
Threaded Mode