![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#12
|
|||
|
|||
![]()
On Sun, 16 Dec 2012 17:12:24 -0700, Dan Marotta wrote:
Been a long time since EE school, but, IIRC, "switching on and off" creates a LOT of RF noise. Even at those low voltages and currents? But what does solving the problem by fitting a simple capacitor across the supply say about the relative amounts of RV vs. electrical noise? Bear in mind that there's around 50cm of unshielded cable between the capacitor on the switch and the T&B - cable that was supplied with it. -- martin@ | Martin Gregorie gregorie. | Essex, UK org | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Trying again: Collings Foundation B-17 at Newcastle Airport inDelaware - B-17 cockpit.jpg - B-17 cockpit.jpg (1/5) | Jim Breckenridge | Aviation Photos | 1 | August 30th 08 07:36 PM |
Trying again: Collings Foundation B-17 at Newcastle Airport in Delaware - B-17 cockpit.jpg - B-17 cockpit.jpg (0/5) | Go-dot | Aviation Photos | 0 | August 28th 08 11:39 PM |
Wings of Freedom B-17 Wilmington, DE - B-17 cockpit.jpg - B-17 cockpit.jpg (0/5) | Go-dot | Aviation Photos | 0 | August 28th 08 09:37 PM |
Retraction (lowering?) assist springs on V2C | [email protected] | Soaring | 1 | January 5th 06 05:20 PM |
Lowering Stall | Dick | Home Built | 7 | December 25th 03 03:19 PM |