|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
December 20th 12, 03:58 PM
posted to rec.aviation.soaring
|
|||
|
|||
Lowering cockpit RF interference
Thank you Dan for your article link
John DeRosa wrote: Your question is less about "I have a problem and want to fix it." versus, "I don't want any problems in the first place. Exactly. Do late model sailplanes actually have a "factory" grounding point? Am I correct to assume the best grounding point would be the heaviest metal frame work closest to the instrument panel such as the control yoke or the adjustable rudder pedal track? So in the perfect world all things metal (especially long lengths like push rods) and your negative instrument buss should be grounded to a common ground point? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trying again: Collings Foundation B-17 at Newcastle Airport inDelaware - B-17 cockpit.jpg - B-17 cockpit.jpg (1/5) | Jim Breckenridge | Aviation Photos | 1 | August 30th 08 07:36 PM |
| Trying again: Collings Foundation B-17 at Newcastle Airport in Delaware - B-17 cockpit.jpg - B-17 cockpit.jpg (0/5) | Go-dot | Aviation Photos | 0 | August 28th 08 11:39 PM |
| Wings of Freedom B-17 Wilmington, DE - B-17 cockpit.jpg - B-17 cockpit.jpg (0/5) | Go-dot | Aviation Photos | 0 | August 28th 08 09:37 PM |
| Retraction (lowering?) assist springs on V2C | [email protected] | Soaring | 1 | January 5th 06 05:20 PM |
| Lowering Stall | Dick | Home Built | 7 | December 25th 03 03:19 PM |
Threaded Mode