|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
January 1st 13, 08:04 PM
posted to rec.aviation.soaring
|
|||
|
|||
WinPilot locked up my Vertica 2 PNA - help!
On Tuesday, January 1, 2013 8:31:37 AM UTC-7, wrote:
I've managed to lock my Vertica 2 PNA up with WinPilot, and can't get it un-frozen. Holding down the power button, even for an extended period doesn't do anything. Anyone know if there is a reset button? On the back of the V2, is a very small hole. Not where the speaker holes are, but the opposite side. Using a very small wire, insert and then push the reset button. Just like you would do on a IPAQ. BUT the V2 stylist will not work as it doesn't go in deep enough. Which requires a small wire. Mine resets with no problem doing this. Also, go to the Oudie Naviter site and theirs a good picture their. #711. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Notes on the Vertica 2, Gliderguider PNA | Tom Kelley #711 | Soaring | 19 | November 1st 12 07:19 PM |
| Pilot locked in F22 | 601XL Builder | Piloting | 14 | April 29th 07 06:19 PM |
| That's one way to get the gear down and locked | Louis L. Perley III | Piloting | 17 | September 19th 05 09:16 PM |
| WinPilot Offers Free WinPilot XP for your Desktop Computer | Richard Pfiffner | Soaring | 0 | November 8th 03 04:44 PM |
Threaded Mode