|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
March 15th 13, 01:51 AM
posted to rec.aviation.soaring
|
|||
|
|||
FLARM antenna question (hindrance from metal)
On Thursday, March 14, 2013 6:07:35 PM UTC-7, 2NO wrote:
I am going to wave my white "not a hardware guy" flag again here (while ducking). If the (main) FLARM antenna is mounted on a tin or aluminum surface (specifically, a short length of 0.5 by 0.1 inch of what is tin, aluminum, or some other light metal), will it interfere with the antenna's performance? Or should I go with the wood alternative ... ? ~ted/2NO See for some antenna solutions. http://www.craggyaero.com/cables_&_antennas.htm Richard www.craggyaero.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Q: Position of external Flarm RF antenna on tow plane Aviat Husky A1 | RuudH | Soaring | 5 | December 20th 12 04:58 PM |
| Again with FLARM antenna questions. | brianDG303[_2_] | Soaring | 0 | July 23rd 12 05:35 PM |
| Antenna Install in a Metal Glider | Markus Graeber | Soaring | 15 | April 10th 12 07:57 PM |
| Power FLARM question | Kimmo Hytoenen | Soaring | 26 | March 23rd 12 04:28 AM |
| FLARM antenna installation | Kevin Neave | Soaring | 5 | January 16th 07 06:53 PM |
Threaded Mode