|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#21
May 16th 13, 04:11 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFLARM firmware v3.00 released (feature complete)
On Thursday, May 16, 2013 8:58:46 AM UTC-4, Andrzej Kobus wrote:
I have a brick and I still can't update a config file or firmware with this cable because I don't see the LED on the unit. I actually need to take off the canopy. Is there solution to this problem coming? Shouldn't a display show this LED status through the communication protocol. This a big pain in the rear end. Stop whining and follow the instructions. Yes, display units report the status of software updates, IGC file downloads, etc... Really now... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| PowerFLARM Portable - Firmware Update Available - Mode C Traffic Now Supported | Paul Remde | Soaring | 24 | January 22nd 12 01:50 AM |
| New ILEC SN-10 Firmware | Paul Remde | Soaring | 5 | August 25th 05 08:11 PM |
| v3.20 Firmware now out for Garmin 296 {nt} | Cockpit Colin | Piloting | 0 | March 8th 05 01:12 AM |
| Garmin 196 firmware update v3.1 released | Aloft | Piloting | 0 | August 13th 03 12:50 AM |
Threaded Mode