![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#9
|
|||
|
|||
![]()
On Thu, 08 May 2014 15:42:42 -0700, Dave Nadler wrote:
The FLARM message sets for traffic and collision warnings are very well documented and used by at least a dozen other manufacturers and software packages to display FLARM info. See "Data Port Spec": http://www.flarm.com/support/manual/index.html Thanks for the link, Dave. Bookmarked. -- martin@ | Martin Gregorie gregorie. | Essex, UK org | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
note to fellow selves - SYM upgrade and baud rates | 2NO | Soaring | 0 | April 20th 12 11:07 PM |
WestJet B-737 With The Sun Setting | Canuck[_10_] | Aviation Photos | 0 | September 4th 10 05:07 PM |
Cruise RPM setting | john | Piloting | 22 | October 18th 07 07:46 PM |
Question: Standard rate turns, constant rate turns, and airspeed | Robert Barker | Piloting | 5 | April 15th 07 04:47 PM |
Setting QNH | BTIZ | Piloting | 31 | March 12th 04 04:29 PM |